0I33A X'cuu' BURST MODE DEVICE ON BYTE MULTIPLEXOR CHANNEL
Cause: A tape or DASD device is specified on a byte multiplexer channel but no support for
burst mode devices on a byte multiplexer channel is present in the supervisor.
System Action: The system waits for an operator response.
Programmer Action: Check the IPL deck and the supervisor listing to determine whether an
ADD card or DVCGEN macro contained a wrong channel or device type. If not, reassemble the
supervisor and specify BMPX=YES in the PIOCS macro.
Operator Action: Enter a DEL command for the given device and then reissue the SET
command. If you are using a card reader for IPL or if the problem recurs, have
· a stand-alone dump (see DOS/VS SADP)
· supervisor listing
· log sheet or IPL deck
available for problem determination.
Used with Courtesy and Permission of International Business Machines, Inc.