0P32 NON COMPAT
Cause: The magnetic tape is written in a density (200, 556, 800, or 1600 BPI) that cannot be
read by the tape unit.
Programmer Action: Check the mode setting used when the tape was created, then:
Recreate the tape in a density or mode compatible with the input drive, or
Set the mode of the input drive to match the one used to create the tape, or
Use a drive compatible with the one on which the tape was created.
If the problem recurs, have the
· log sheet
· printer output
· job stream
· failing tape
available for problem determination.
Operator Action: See Figure 4 at the beginning of this section. Then, check that the tape
was mounted on the correct drive and that the proper mode setting was used.
Used with Courtesy and Permission of International Business Machines, Inc.