Definition of 0P37

 

0P37 DISEN FAIL
Cause: The disengage command was not executed because the photo cell at detection station
number 2 (station B for 1259) is inoperative. This message applies only to 1419 or 1259.
This is probably a hardware error.
Programmer Action: none.
Operator Action: See Figure 4 at the beginning of this section. Clean photo cell 2 (station B
in 1259), reload the reader, press SINGLE CARD, then press START.
If the problem recurs, issue the ROD command, execute EREP (see DOS/VS SADP) and have
the
· output
· log sheet
· printer output
available for problem determination.





Used with Courtesy and Permission of International Business Machines, Inc.