VintageBigBlue.org

 

Message - 0T11W


Nov 28, 2018

 

0T11W HARD WAIT CODE = x
RUN EREP RECORDING SUCCESSFUL
RUN SEREP RECORDING INCOMPLETE
RUN SEREP RECORDING UNSUCCESSFUL
Cause: A system failure, indicated by the hard wait code has resulted in an uninterruptable
wait state. The system failure can be:
x = A irrecoverable machine check has occurred.
B An RMS fetch error occurred.
C Channel failure on SYSLOG when MCAR/CCH message, other than 0T11I, is issued.
D ECSW not stored.
E The ERPIB queue is exhausted.
F Two channels are damaged, or a channel error occurred while RMS was performing
an I/0 operation.
G System reset was presented by a channel in the ECSW.
H The reset codes in the ECSW are invalid.
I The channel address of a channel error is invalid.
J irrecoverable channel check on paging channel.
The second part of the message indicates the error editing program that should be executed
and whether error recording was successful, incomplete, or unsuccessful.
This is probably a hardware error.
System Action: The system enters an irrecoverable wait state.
Programmer Action: none.
Operator Action: Execute the program indicated by the error message. SEREP should be
executed immediately. If EREP is indicated. you must IPL and then supply a job stream to
execute EREP. See DOS/VS SADP. In both cases. call your IBM customer engineer.
Consult DOS/VS SADP, for Model 115 or 125 procedures.





Used with Courtesy and Permission of International Business Machines, Inc.


Contact Us
This Site's Privacy Policy
Google's privacy policies

S
e
n
i
o
r
T
u
b
e
.
o
r
g