2116I CONTROL STATEMENT IN OBJECT MODULE
content of statement in error
Cause: Control statement present between first ESD statement and END statement of a
System Action: The invalid statement is ignored and processing continues, unless ACTION
CANCEL was specified to cancel the job.
Programmer Action: Refer to card format 1, linkage editor input cards (DOS/VS System
Control Statements, under Linkage Editor) and compare this with the output on SYSLST. Some
probable errors are:
· job stream is out of order.
· section of the object deck is missing (there is no END card).
Correct the job stream and resubmit the job, or recompile the problem program.
If the problem recurs. have the
· linkage editor map
· log sheet
· job control cards
· object modules
available for problem determination.
If the program was compiled again, have the source deck and the program listing available.
Operator Action: none.
Used with Courtesy and Permission of International Business Machines, Inc.