3E33A ENTER RDE SUMMARY PARAMETERS START DATE,END DATE,IPL INTER-
VAL.COMPANY YYDDD,YYDDD,M OR MM,COMPANY
Cause: Issued by EREPRDE. The EREP program is requesting that the operator enter the RDE
summary parameters. Note that the lines of the message that describe the format, are only
written the first time this message is issued.
System Action: The EREP program waits for a response on SYSLOG.
Programmer Action: none.
Operator Action: Reply in one of three ways:
1. Enter CANCEL to cancel the RDE summary option.
2. Enter the RDE summary parameters, separated by commas, in the form:
the first yyddd is a Julian date. after 1970, at which the program should start summarizing
the RDE information. Default: First date encountered on RDE tape.
The second yyddd is a Julian date. after 1970, at which the program should stop summa-
rizing RDE information. Default: Last date encountered on the RDE tape, or thirty days
from the start date, whichever is less.
mm or m is the interval, in minutes, for clustering IPLs. Default: No clustering is per-
zzz...z is the company name. The maximum length is 55 characters, including blanks.
Default: None. No company name will appear on the report.
Note that any of the first three parameters may be defaulted by not entering any charac-
ters between commas.
3. Press END/ENTER to continue RDE summary using defaults for all parameters.
Used with Courtesy and Permission of International Business Machines, Inc.