Definition of 4Q47I

 

4Q47I 2740-2
Cause: One of the error-indicating leading graphics has been received in response to address-
ing from a 2740, Model 2. The specific response is shown in the message as the first byte of
sense data. This message is in the same general format as messages 4025-4039.
System Action: Normal QTAM operation continues.
Programmer Action: none.
Operator Action: See introduction above message 4Q25I. Check the error-indicating response
that is shown as the first byte of sense data. The error was probably caused by the user if the
response is one of the following:
10 - terminal in local mode
13 — terminal out of paper
20 - document device down
Contact the terminal operator to correct an apparent operating error.
If the response was anything but the preceding, this is probably a hardware error.
If the problem persists. have the
· system log showing this message
· ROD command output
· EREP output (see DOS/VS SADP)
available for problem determination.





Used with Courtesy and Permission of International Business Machines, Inc.