8061I CONTROL RECORD NOT FOUND
Cause: The first data record read was not a control record. The control record is written by
the copy program and contains parameters unique to this file. This message can occur if a
tape is mounted out of sequence, the wrong tape is mounted, or the wrong pack is mounted.
System Action: The job is canceled.
Programmer Action: Correct the assignments or correct the input and resubmit the job.
If the problem recurs, have the
· job stream
· system log
· printer output
available for problem determination.
Operator Action: Check that the correct pack or tape is mounted and that the assignments
are correct. If correction is necessary, rerun the job.
Used with Courtesy and Permission of International Business Machines, Inc.