Definition of S220A

 

S220A MISSING JOB CARD
GIVE REPLY. and/or END/ENTER and INTRPT KEY.
Cause: The first control statement for each job must be the // JOB card. This statement was
not found by the job control program at the point where it should have been encountered.
System Action: The system stops processing and waits for an operator response.
Programmer Action: none.
Operator Action: Resubmit the job control cards, placing the // JOB card ahead of the
others; then enter R or RETRY (or enter no reply) to continue processing, or
Enter C or CANCEL to cancel the job.
After entering your response, press END/ENTER and then INTERRUPT.
Note: The message will appear on the console device only if an assignment for SYSLOG has
been made by placing the appropriate REP card in the supervisor object deck. Otherwise, the
system will be unable to display the message since the job control card assigning SYSLOG will
not yet have been read.





Used with Courtesy and Permission of International Business Machines, Inc.